Weakness · Medium
CWE-1232: Improper Lock Behavior After Power State Transition
What it is
Register lock bit protection disables changes to system configuration once the bit is set. Some of the protected registers or lock bits become programmable after power state transitions (e.g., Entry and wake from low power sleep modes) causing the system configuration to be changeable.
- Severity (our rating)
- Medium
- Likelihood of exploit
- Not rated by MITRE
- Introduced during
- Architecture and Design, Implementation
- Exploited in the wild
- No CVE in CISA's catalog
In more detail
Devices may allow device configuration controls which need to be programmed after device power reset via a trusted firmware or software module (commonly set by BIOS/bootloader) and then locked from any further modification. This action is commonly implemented using a programmable lock bit, which, when set, disables writes to a protected set of registers or address regions. After a power state transition, the lock bit is set to unlocked. Some common weaknesses that can exist in such a protection scheme are that the lock gets cleared, the values of the protected registers get reset, or the lock become programmable.
What an attacker can do
- Modify Memory (Access Control)
How to prevent it
Architecture and Design
- Security Lock bit protections should be reviewed for behavior across supported power state transitions. Security lock programming flow and lock properties should be tested in pre-silicon and post-silicon testing including testing across power transitions.
H2 Security
Found it in your code?
We review where it appears, fix it with your team, and check it was not already used against you.
Talk to our teamT Academy
Stop writing it in the first place
Learn to build software and systems without weaknesses like this one, with practice on real hosts in your browser, every objective checked on the machine.
Start freeSource: MITRE Common Weakness Enumeration, CWE version 4.19.1. CWE is a trademark of The MITRE Corporation.